ENET-PN-S function

1. Installed on a 35mm rail, LAN1 is a four-port RJ45, with switch function, this port is connected to PLC; LAN2 is a single-port RJ45, which can be connected to a touch screen or host computer system; WiFi external high-gain antenna, can be connected to the host computer; ENET is powered by an external 24VDC power supply.

2. Integrated WiFi function, support AP mode, STA mode and AP STA mode.

3. PLC programming, data acquisition, data exchange and cross-network segment access can be carried out through WiFi.

2. Integrated WEB server, through the web page can set equipment parameters and run diagnosis; It can also be configured via the BCDevice tool; It can be configured arbitrarily from the LAN1/LAN2 interface or WiFi.

3. To realize NAT function, the module can be configured with 4 groups of forwarding ports, and each group of forwarding ports can be connected by multiple TCP or UDP;

4. SmartIE series touch screen can be connected to S7-1200, S7-1500 and other PLCs.

5. The LAN2/WiFi interface can support the ModbusTCP server function, and the PLC connected to the LAN1 port can be mapped to the ModbusTCP server of the LAN2/WiFi interface.

6. The LAN2/WiFi interface can realize the TCP client, based on the ModbusTCP or S7TCP protocol, to realize the data exchange between PLCs and the ModbusTCP instrument data reading.

7. The LAN2/WiFi interface can support the ENETS7 protocol server function, and the PLC connected to the LAN1 port can be mapped to the ENETS7 protocol server of the LAN2/WiFi interface.

8. The LAN2/WiFi interface can support up to 32 host computer access.

9. SCADA (superstructure software) that supports OPC channel communicates with PLC in OPC mode.

10. Support the user side to realize firmware update through Ethernet, one-time purchase, permanent upgrade.