Technical features:

1. Installed on a 35mm rail, LAN1 is a dual-port RJ45, with switch function, this port is connected to PLC; LAN2 is a single-port RJ45, which can be connected to a touchpad or host computer system; WiFi external high-gain antenna, can be connected to the host computer; The ENET-MIT-S is powered by an external 24VDC power supply.

2. Integrated WiFi function, support AP mode, STA mode and AP STA mode;

3. PLC programming, data acquisition, data exchange and cross-network segment access can be carried out through WiFi;

4. Integrate WEB server, set equipment parameters and run diagnosis through web page; It can also be configured via the BCDevice tool; It can be configured arbitrarily from the LAN1/LAN2 interface or WiFi.

5. Realize Mitsubishi's internal protocol MELSOFT connection, which can map the MELSOFT protocol to the ModbusTCP and MC (3E frame) server of LAN2/WiFi, and realize the connection of ModbusTCP and MC (3E frame) protocol without configuring Mitsubishi PLC.

6. Implement NAT function, map the IP address and port number of the PLC connected to the LAN1 port to any IP and port number of LAN2/WiFi.

7. LAN2/WiFi can support ModbusTCP server function, and the PLC connected to MELSOFT can be mapped to the ModbusTCP server of LAN2 port; The mapping relationship between Modbus and Mitsubishi PLC internal software components can be freely edited.

8. LAN2/WiFi can support MC (3E frame) protocol server function, and the PLC connected to MELSOFT can be mapped to the MC (3E frame) protocol server of LAN2/WiFi, which is convenient for OPC to use Mitsubishi Ethernet drive function.

9. LAN2/WiFi can support up to 32 host computer access.

10. SCADA (superstructure software) that supports OPC channel communicates with PLC in OPC mode.

11. Support the user side to achieve firmware update through Ethernet, provide firmware that integrates more functions for free, purchase hardware once, and upgrade permanently.